#Pcclone ex lite error code 3 driver

Info (209011): Successfully performed operation(s) Info (209007): Configuration succeeded - 1 device(s) configured Info (209017): Device 1 contains JTAG ID code 0x0318A0DD Info (209016): Configuring device index 1 *** TEST 2 Using programmer version 15.0 same hardware same platform:Д«lank check proceed to 100% so 18.x 19.1 erasure work for sure. This is spread on all my board and Terasic too. (NA on Terasic due to integrated programmer).

sof can be loaded in ram also without power cycle of my custom board. Verify leave board in an unknown state, old image never load at end of operation.ДЄfter power cycle of USB Blaster and regaining control of USB Blaster then a. pof files.ДЄfter one of that operation Fpga remain in a limbo state, programmer never work again and require a power cycle. Unsuccessful operation: program, verify, blank check flash with. Programmer of latest version (18.x,19.1) fail reporting failure 0% after a while. (install Quartus on win7 require a huge amount of time compared to few minutes on Linux/MAC so I am not interested test more on.) Try'd on a stand alone Win7 only, same issue on device drivers, so again I cannot test native winzz USB blaster drivers.

#Pcclone ex lite error code 3 driver

I don't use winxx platform, try'd on VM win 7 Pro where I use Terasic tools thru linux USB Blaster server, programmer 18/19 same issue.ДЇailed to setup USB blaster native driver on that platform. Programmer: USB blaster, Terasic embedded programmer on DE10 Lite. Quartus II lite 18.1 (programmer from 19.1 same) Target MAX10SC 08 and 50 BGA484 Terasic DE10Lite, RoketBoard Arrow/terasic DECA